Es’hail-2 Transponder Tests + Narrow Band Web Stream

eshail dish fine tune

Es’hail 2 was launched last November and it is the first geostationary satellite to contain an amateur radio transponder. The satellite is positioned at 25.5°E which is over Africa. It’s reception footprint covers Africa, Europe, the Middle East, India, eastern Brazil and the west half of Russia/Asia.

Although the satellite was launched last year, turning on the amateur transponders has been slow because the commercial systems of the satellite have higher priority for testing and commissioning. However, within the last day the Es’hail 2 team have now begin testing the amateur transponder, and the test signal has been successfully received by several enthusiasts (just check out the Twitter feed). There also appears to have already been a suspected pirate CW signal broadcasting “WELCOME DE ES2HAIL”. Actual uplink use of the satellite is not currently wanted, and from the Amsat forums one of the engineers writes:

Before the IOT starts there will be a TRR (test readyness review) in front of the customer. All the testplans and test-specifications will be reviewed. When the test is done there will be a TRB (test readyness board). In the TRB they have to show/present all the measurement results (e.g. inband performance like Gainflatness, Groupdelay… aso.) and compare these results with the specification in the contract. Each unwanted signal makes the measurement difficult and needs to be explained or leads to a so named NCR (non conformance report).

The IOT will be done in shifts/nightshifts and with unwanted signals (if not explain able) some measurements needs to start again and again and leads in addition to a delay for the handover and operation of the satellite.

Maybe that helps to understand why it is really important to have only the IOT uplink signal.

To measure the pattern of each antenna the satellite will be moved east/west by the propulsion system of the DS2000 Bus and the signal level is measured by the IOT station on ground (some cuts) .

The commercial beacon can maybe be switched from LEOP Omni antenna to on station antenna when the satellite is placed in the final slot. This should be the reason for the change of the commercial Ku Band beacon signal level the last days.

If you are interested in receiving Es’hail 2, but live outside the footprint, or don’t have a receiver then you can use Zoltan’s OpenwebRX live stream of the narrow band portion of the Es’hail 2 downlink. At the moment the beacon doesn’t appear to be transmitting, but we expect it to be on and off during the next few days. In his set up he uses an RTL-SDR V3, Inverto LNB, 90cm dish, a DIY bias tee and a Raspberry Pi 3.

He also took a recording of the pirates CW transmission shown in the video below.



View All